samsung j7 2016 sim card ways

Samsung Galaxy J7 (2016) J710F sim card ways jumper

After assembly, samsung galaxy j7 2016 check all motherboard sim socket points with a counter. Check all these parts and the path shown in the diagram above and if any are missing, apply jumpers to make this path good. If any of the components are missing, replace it with a new one.samsung galaxy j7 2016.

pic Galaxy J7 (2016) J710F sim card ways jumper
Samsung Galaxy J7 6 sim card ways
You can also change SIM cards and jumpers can be applied after removing the motherboard from the motherboard.

samsung galaxy j7 2016 Insert Sim Card Problem Solution Jumper Ways

For more information, tips and tricks on this problem solution, keep visiting this page and we will update it if there are new updates. As some related articles are shown below, you can read more about mobile.

Please note that although each diagram and solution displayed on our website has been tested by one or more members of our team before publication, therefore we will not be liable for any loss or damage, including personal injury. Use these repair solutions at your own risk.


Samsung Galaxy J7 J700F Sim Card Ways
Samsung Galaxy J7 J700F Sim Card Ways


For a Samsung Galaxy J7 (2016) J710F, if you're experiencing issues with the SIM card not being detected or not working properly, it could be due to damaged or disconnected SIM card pins or traces on the device's logic board. In such cases, you might need to perform a jumper or repair to restore connectivity.

Please note that attempting any hardware repairs on your device carries risks, and it's advisable to seek assistance from a qualified technician if you're not experienced in this area. Additionally, opening your device may void its warranty.

Here's a general guide on how to perform a jumper for SIM card connectivity issues on a Samsung Galaxy J7 (2016) J710F:

Prepare Necessary Tools: 

You'll need a set of precision screwdrivers, a heat gun or soldering iron, soldering flux, soldering wire, and a magnifying glass (optional but helpful for detailed work).

Disassemble the Device: 

Power off the phone and remove the back cover, battery, and any other components necessary to access the logic board.

Locate the SIM Card Slot:

On the logic board, locate the SIM card slot and inspect it for any visible damage or disconnected pins.

Inspect for Damage:

Carefully examine the area around the SIM card slot under magnification to identify any damaged or broken traces.

Perform Jumper:

If you've identified a damaged or disconnected trace, you'll need to create a jumper by soldering a fine wire to bridge the gap between the two points. Be extremely careful and precise during this process to avoid causing further damage.

Test Connectivity:

 Once the jumper is in place, reassemble the device (partially if needed) and test the SIM card functionality to see if the issue has been resolved.

Reassemble and Test:

 If the SIM card is detected and functions properly, reassemble the device fully. If not, you may need to recheck your jumper connections or seek further assistance.

Please keep in mind that this is a general guide, and the specific jumper points and procedures may vary depending on the exact nature of the issue and the design of the device. If you're unsure or uncomfortable with performing hardware repairs, it's best to seek professional assistance to avoid causing further damage to your device.
Next Post
No Comment
Add Comment
comment url